Martindale MTL10PD-S Test Lamp Kit

This handy bundle contains a Drummond MTL10 test lamp, a PD440-S proving device and a soft case.

The proving device can be used to verify the functioning of the test lamp.

A Closer Look at the Contents:

Martindale DRUMTL10 Test Lamp

The new Drummond MTL10 test lamp safe voltage indication from 50 - 500V AC / DC. The robust design meets the recommendations of the Health and Safety Executive in their guidance notes on the electrician's test lamp (GS38) as well as complying with BS EN 61243-3 and BS EN 61010, CAT III 1000V and CAT IV 600V.

Both the lamp housing and the probe have a finger shield and insulated probe tip with only 4mm of exposed metal. A two layer double insulated cable with white inner insulation gives a clear warning of abrasion that might compromise the user's safety, and is resistant against heat and oil. To enable use in most circumstances, a right angled probe tip is supplied in addition to the two straight tips. For maximum ease of use the right angled probes can be rotated through 90, 180 and 270 degrees.

A unique feature of this new Drummond test lamp are the four distinctive bands of illumination, with a 360° viewing angle, providing indication of voltages above 50, 100, 200 & 400 volts, even in bright sunlight. This allows for accurate identification of potentially lethal voltages at 50V and enables the user to distinguish between 110V, 230V and phase to phase voltages in a 3 phase system.

Martindale PD440-S Proving Device

The Martindale PD440-S is a 440V AC proving device, designed to enable voltage indicators to be fully checked, in compliance with Health & Safety recommendations. Using a voltage indicator without first proving it is working correctly could prove fatal.

The PD440-S is compatible with the Martindale VI13800 & the Martindale VI13700.

It can also be used to check Drummond and other filament test lamps as well as standard multimeters and other manufacturers two pole voltage indicators.

There is now a facility to power the PD440-S proving devices with the addition of a 12V DC power connection point. The units can be powered by either alkaline batteries or a 12V power supply. There are two power supply units available for the proving devices, the PSUPD230 and the PSUHPAT12. The PSUPD230 can be connected to mains power and the PSUHPAT12 is a 12v power supply suitable for use in a car/van cigarette lighter.

Drummond MTL10 Specification

Maximum Working Voltage

• 500V AC, 750V DC

Voltage Ranges

• 50, 100, 200, 400V AC / DC

Range Detection

• Automatic

Response Time

• <0.1s

Frequency Range

• DC, 0-65Hz

Test Current (500V AC / DC)

• <3.5mA

General Specifications

• Temperature Range: -10°C to +55°C
• Measurement Category: CAT IV 600V, CAT III 1000V
• Pollution Degree: 2
• Protection Degree: IP64
• Dimensions: 213 x 112 x 72mm
• Weight: 320g approx